Table of Contents
Advertisement
Quick Links
TRITON ™ Installation Instructions
TRITON ™ Installation Instructions
TRITON ™ Installation Instructions
SAFETY INSTRUCTIONS
Read and understand this entire manual before attempting to assemble, operate, or install the LED Luminaire. If you
have any questions regarding the product, please call TGS Customer Service at (818) 206-4404.
1. All electrical work must conform to the National Electric Code (NEC) and all applicable local codes and ordinances.
2. Only quali ed personnel shall install and maintain the luminaires. TGS recommends that a licensed electrician install and maintain
the luminaire. Verify the safety of existing power distribution system before beginning installation. FAILURE TO FOLLOW OPERATING
INSTRUCTIONS MAY LEAD TO DEATH, SEVERE INJURY, OR PROPERTY DAMAGE.
Turn o power before performing any electrical or control work. FAILURE TO FOLLOW THIS WARNING MAY LEAD TO DEATH,
SEVERE INJURY, OR PROPERTY DAMAGE.
DO NOT make or alter any open holes in the luminaire. Do not modify the luminaire.
Follow all applicable safety procedures and use Personal Protective Equipment such as hardhats, safety glasses, re ective vests,
electrical safety gloves, fall protection equipment and safety toe boots during the installation, operation, and maintenance of the
luminaire. FAILURE TO FOLLOW THIS WARNING MAY LEAD TO DEATH, SEVERE INJURY, OR PROPERTY DAMAGE.
Risk of eye injury! Eye protection is required at all times during the installation, operation, and maintenance of the luminaire. The
high intensity light produced by the luminaire can cause severe damage to the eye if viewed directly at close range. Avoid being
in front of a luminaire that is on or wear suitable light blocking protective eyewear such as welding goggles.
Store luminaires in a clean, dry place, protected from dirt, water, and sunlight. See table for required storage and operating conditions:
Storage Temperature
Operating Temperature
40°F to 167°F
WARNING
WARNING
-20°~131°F
5% to 95% non-condensing
Humidity
Advertisement
Table of Contents
Summary of Contents for TGS TRITON 500W
- Page 1 1. All electrical work must conform to the National Electric Code (NEC) and all applicable local codes and ordinances. 2. Only quali ed personnel shall install and maintain the luminaires. TGS recommends that a licensed electrician install and maintain the luminaire. Verify the safety of existing power distribution system before beginning installation. FAILURE TO FOLLOW OPERATING INSTRUCTIONS MAY LEAD TO DEATH, SEVERE INJURY, OR PROPERTY DAMAGE.
- Page 2 TRITON ™ Installation Instructions TRITON ™ Installation Instructions Product Features: The material of heat sink is high thermal conductivity cold-forging aluminum,good for heat dissipation and the surface is anti-static. The unique design of housing help to speed up the heat dissipation,further ensuring the life of the fixture. The integrated design of appearance makes the fixture looks elegant.
- Page 3 TRITON ™ Installation Instructions TRITON ™ Installation Instructions 500W Mounting hole drawing 200.0 Ø62.5 R5.3 Ø21.0 Mounting surface plate Binding bolt 35.0 M20 Bolt M20 Nuts 5:Adjust the beam angle 3: Put the plain washer& lock washer in the M20 bolt 1: Fix the M20 bolt at the mounting surface plate 6:Lock the binding bolt to fasten the light body 2:Fix the rotatable bracket on the M20 bolt...
- Page 4 TRITON ™ Laser Guide Instructions Laser Guide Screw Screw “L” type holder Laser holder A x the laser guide in to the laser holder Insert the “L” type holder at the bottom To lock the “L” type holder tighten the Tighten the middle screw on the holder of the laser holder two end screws on the laser holder.
Need help?
Do you have a question about the TRITON 500W and is the answer not in the manual?
Questions and answers