Safety information Before installing, powering up, or servicing the StarEye Mini RGBW led-unit, it is highly recommended that you read this manual and ensure yourself that you completely understand its content. Observe the safety precautions in this manual. Install and operate the led-unit only as described in this manual, and in conformity with local regulations.
It might be necessary to allow the led-unit to cool down for 5 minutes, before servicing. Do not modify the LED fixture, in a way, not described in this manual. StarEye Mini RGBW p.6/17 LUX LUMEN - Kernenergiestraat 53A - 2610 WILRIJK - BELGIUM T: +32 3 293 35 50 –...
European community: waste electrical and electronically equipment. Please help to preserve our environment and ensure that this product will be recycled properly at the end of its life. StarEye Mini RGBW p.7/17 LUX LUMEN - Kernenergiestraat 53A - 2610 WILRIJK - BELGIUM T: +32 3 293 35 50 –...
Physical installation Thank you for selecting this StarEye Mini RGBW led-unit as best solution in your setup. Warning! Read the safety precautions in this manual before integrating this led-unit into your installation. Installation must be carried out by qualified professionals only.
In case of inversed polarity, the warranty is void. Power supply: Rated voltage The rated input voltage range of the StarEye Mini RGBW led-fixture is 24 volt DC. Due to the use of a step down-convertor, integrated in the housing, a highly efficient system is created.
EMC and safety requirements The StarEye Mini RGBW led-unit is fully compliant to the LVD and EMC directive of the European council, if used in a properly designed setup. EMC requirements of the power supply The StarEye Mini RGBW led-unit is only intended to be used in lighting applications, and as such, the complete assembly of led-unit and power supply needs to be fully compliant with the harmonized standards.
Installation setup 7.1 Specification The StarEye Mini RGBW led-unit is a small and efficient solution for indoor detail lighting (IP20) It uses a simple stabilized DC power supply of 24 volt DC. It is possible to use an anti-glare filter to manipulate the light output.
8.2 Cleaning The StarEye Mini RGBW led-unit itself Extensive dirt, and particle build-up degrades performance, may cause overheating can result in damaged led-unit and power supplies. Damage by inadequate cleaning or maintenance is not covered by the product warranty.
Screw the front cover counterclockwise to remove it from the led-unit. Step 2: Take out the old lens. Don’t touch the LED itself to avoid damage to the StarEye Mini RGBW! Step 3: Insert the new lens into the led-unit.
Need help?
Do you have a question about the Mini RGBW and is the answer not in the manual?
Questions and answers