Champion instruments WR1 Programming Manual

Champion WR1
Radio Programming Guide
Step
In order to configure the Radios in the WR1 receivers you must have the WR1 Radio
1
*PLEASE NOTE: The FCC requires that you license your UHF radios. That is the user's responsibility
a) Connect your WR1 receiver to the
computer using the USB cable that came
with the system.
b) Make sure you have a Full Battery
c) Power the receiver on
2
d) Press the "Power" button to Make Sure it is
in "UHF Rover/Base mode" (if not follow
instruction in the user's manual)
e) If you have not previously connected with a
USB cable follow the USB connection
guide
a) Run the GM-xxPx Radio Management
1.2.5 or greater Software by double
clicking the install link
b) Select the proper "Com" Port
c) Press the "OPEN" button then
3
"CONNECT"
d) You will see a Blue Bar across the Bottom
then a message "CONNECT OK"
e) Press "OK"
Champion Instruments
Action
Management Software 1.25 or Greater.
and not Champion Instruments or its representatives.
(678) 386-2208 | www.ChampionInstruments.com
Display
Page 1/2