Status Indicators - Philips SHB6110/00 User Manual

The table below shows how to operate your headset:
In order to:
Enter pairing mode
Turn headset on
Turn headset off
Play / Pause music
Stop music
Skip Fwd/Bwd
FullSound on / off
Adjust volume
Pick up a call / End a call
Pick up a 2 call / put other call
nd
on hold / switch back*
Reject a call
Redial the last number
Activate voice dialing*
Mute Mic
Transfer call to phone*
Other status indicators:
Connected to Bluetooth device
(while in standby or while
listening to music)
Ready for pairing
On but not connected
In call
Low battery
* Available if supported by your mobile phone
Do this:
Press until the LED starts
blinking red / blue alternately
Press for 2 seconds
Hold for min. 4 sec
Tap
Tap and simultaneously
Tap or
Hold and simultaneously
for 4 sec.
Tap VOL- or VOL+
Tap
Tap
Hold
Double tap
Hold until "beep" sound
Double tap (during call)
Hold
Blue light flashes every 3 seconds.
In pairing mode, LED flashes continuously alternating red and
blue.
Blue light flashing fast
While call is ringing, blue light flashes fast (twice per second).
After call pick up, slows down to once per second.
LED will flash red instead of blue. A short double beep will
be heard every minute with five minutes or less of talk time
remaining.
Sound and LED indicator
feedback
Alternating red/blue flash
• 3x red flash: battery is low.
• 2x red flash: > 25% of
charge remaining.
• 1x blue flash: > 50% of
charge remaining.
One long beep
One short beep: On
Two short beeps: Off
One long beep
Two short beeps
One short beep
Short beep every five
seconds until mute is turned
off.
One short beep
11