Advertisement
Use
Cleaning & Disinfection
After
every
please
following steps:
•
Remove the rotating tool
first. Then handle the tool
according to the instructions
of its manufacturer.
•
Remove tissue remains by
wiping off the unit with a
mildly
moistened
cloth. Afterwards clean all
surfaces
with
cloth
(e.g.
Tücher of Schülke and Mayr)
There is no limit to the
number of times this device
can
be
disinfected
recommended lifespan.
Area of Application
The massaging scrubber allows
a variety of treatments and
cleaning
of
handpiece can hold all hadewe
brush
attachments.
attachments
manufacturers can be used by
using an adapter.
Installation Site
The working area must conform
to the conditions described. Set
up the unit in such a way, that
the air slits are not blocked and
treatment
carry
out
the
paper
disinfection
Mikrozid
AF
cleaned
and
during
its
the
face.
The
Brush
from
other
the extracted air can escape
well. The device must only be
used in closed spaces.
Dismantle handpiece handle
Optionally, the handle can be
disassembled
handpiece. To do this, remove
the cap at the end of the handle.
Loosen the screw inside with the
hexagon key until the handle
can be removed. The threaded
hole on the handpiece is now
closed with the stopper.
Start & Operation
1. Switch off the device at the
knob.
2. Insert the brush attachment
into the handpiece until it
clicks into place.
3. Plug in mains plug.
4. By turning up the knob, you
switch on the device and set
the speed.
Always
handpiece with the tip
pointing down to avoid residual
fluid flowing from the brush into
the handpiece.
5
from
the
place
the
Advertisement
