Table of Contents
Advertisement
Quick Links
MOUNTING INSTRUCTIONS:
The control unit should be mounted on a wall or other vertical surface taking care to
protect it from rain and direct sunlight.
SPECIFICATIONS:
INPUT: 230/240V 10A 50Hz
MAX TOTAL LOAD: 10A
Ip23
WARRANTY:
All products manufactured by Sunbather are warranted against defects in materials and
workmanship for a period of one year from the date of original purchase.
Sunbather will repair or replace, at its option, any product returned to us by the Purchaser
during the warranty period without charge provided that:
(a) Sunbather is promptly notified upon discovery of the defect by the Purchaser,
(b) the defective product is returned to Sunbather, 2174 Frankston-Flinders Road,
Hastings, Victoria 3915 with all shipping, forwarding charges, duties insurance
and taxes prepaid by the Purchaser,
(c) examination of such product by Sunbather discloses that such defects have not
been caused by misuse, neglect, alteration, or repair, and
(d) the Purchaser provides proof of original purchase date. Sunbather reserves the
right to discontinue particular models without notice and to make modification
in design at any time without incurring obligations to make such modifications
to units previously delivered.
The warranty set forth above is the exclusive express warranty.
ALL IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR USE ARE LIMITED IN
DURATION TO ONE YEAR FROM THE DATE OF ORIGINAL PURCHASE. SUNBATHER SHALL
NOT BE LIABLE FOR ANCILLARY, INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES OF
ANY NATURE, INCLUDING, BUT NOT LIMITED TO LOSS OF REVENUES OR PROFIT
RESULTING FROM THE USE OF THIS PRODUCT OR FROM ANY BREACH OF ANY WARRANTY
APPLICABLE TO THIS PRODUCT.
TPS SOLAR CONTROLLER
TEMPERATURE
POOL
SET
ROOF
SELECT
www.sunbather.com.au
MADE IN AUSTRALIA
FOR SERVICE CALL
1800 228 437
SOLAR
POOL HEATING
www.sunbather.com.au
Sunbather Pty Ltd 2174 Frankston-Flinders Road PO Box 107 Hastings Victoria Australia 3915
Operating Instructions
SOLAR
POOL HEATING
AUTO
MANUAL
SOLAR
WINTER
MODE
INPUT: 230/240 50Hz
OUTPUT: 240V 10A
IP23
Q 93126
N786
SERVICE CONTACTS
QLD - 07 3806 5909
NSW -02 9894 7550
ALL OTHER STATES - 03 5979 5777
E:info@sunbather.com.au
Advertisement
Table of Contents
Summary of Contents for Sunbather TPS
- Page 1 All products manufactured by Sunbather are warranted against defects in materials and workmanship for a period of one year from the date of original purchase. Sunbather will repair or replace, at its option, any product returned to us by the Purchaser SOLAR...
- Page 2 To prevent the unit from sampling at night an adjustable setting has been provided. The roof temperature needs to be above this value for the unit to sample. The TPS is a micro processor based solar controller used to heat your pool/spa from your To adjust this value: solar collector.
Need help?
Do you have a question about the TPS and is the answer not in the manual?
Questions and answers
I have one of these units. Over the past six months intermittent issues with the following. The unit has a continual round and round illumination of the led's and temp display. Turning on and off has little effect Unable to change the mode or temperatures Appears all functions disabled At times, like this morning the display of pool temp in Auto is 14 which is good with no other leds going on and off. However still unable to change modes or temps. ust no response. AT other times the unit functions as normal. Weird and intermittent fault. Pressing mode for 5+ seconds has no effect. Turning on and off at mains no effect. Any ideas?