Summary of Contents for Salamander Designs FPSA/RF1
Page 1
Wireless remote control - FPSA/RF1 FPS accessory user manual Wireless Remote Cable Receiver Double Sided Tape 400-630 400-607 400-635 301-245 Install wireless remote 1. Plug cable into receiver (either port is ok to use) 2. Plug opposite end of cable into control box located on unit Salamander Mobile Interactive Display Stand Accessories 501-660 [07.17]...
Page 2
3. Mount receiver using the double sided tape provided. Make sure the hole is pointing down. 4. Pair remote with receiver by pushing in button on receiver with paper clip at the same time as any button on the remote control. Hold both buttons for two seconds then release both buttons at the same time.
Page 3
FPSA/RF1 Español français Deutsch Control remoto inalámbrico Télécommande sans fil Fernbedienung Remoto Inalámbrico Cable Receptor Cinta de dos lados Télécommande sans fil Câble Récepteur Ruban adhésif double face Fernbedienung Kabel Empfänger Doppelseitiges Klebeband 400-630 400-607 400-635 301-245 GARANTÍA LIMITADA PARA STANDS Y SOPORTES DE VIDEO COMERCIALES Salamander se enorgullece de soportar nuestros productos con garantías líderes en la industria.
Page 4
Español Instalar control inalámbrico 1. Conectar el cable al recibidor (se puede utilizar cualquiera de los puertos). 2. Conecte la otra punta del cable en la caja de control ubicada en la unidad. 3. Instale el recibidor utilizando la cinta de doble faz que se ha ofrecido. Asegúrese de que el agujero apunte hacia abajo.