Related Manuals for Cell2 SAS32R
Summary of Contents for Cell2 SAS32R
- Page 1 SAS32R SPEAKER SIREN SYSTEM W/ SW300 CONTROL SWITCH & MIC SET Installation & Operation Manual NOTICE TO INSTALLER Before installation and operation -- read all instructions and warnings. Deliver this manual to the end user of this equipment.
-
Page 2: Table Of Contents
TABLE OF CONTENTS INSTALLATION......................2 MOUNTING........................3 WIRING........................5 CONTROLLER FUNCTION..................6 PA BROADCAST......................7 LOW VOLTAGE PROTECTION MODE............... 7 - 1 -... -
Page 3: Installation
Failure to follow these instructions could result in serious damage to the unit or vehicle and may void warranties. The correct mounting and wiring is the key to the effectiveness of SAS32R & SW300. Installers must read and follow installation instructions and warnings in the manual from the original manufacturer. -
Page 4: Mounting
MOUNTING Speaker Siren Unit Secure the mounting bracket to an appropriate and suitable area. Note: Please only mount the horn facing out horizontally to the ground. RUBBER PAD BRACKET FLAT WASHER SPRING WASHER M6 HEX HEAD NACHIRE BOLT RUBBER MOUNTING BRACKET 0.590"... - Page 5 Switch Panel Handlebar Mount: Select a mounting location that will not interfere or impede the operation and/or function of any existing equipment. Securely mount the switch using the provided handlebar clamp. Handlebar Diameter Ø0.87"~Ø1.26" (Ø22mm~Ø32mm) Surface Mount: When installing surface mount, make sure to consider the thickness of the mounting surface and washer.
-
Page 6: Wiring
WIRING White Car Ignition Key Black POWER -GND POWER +VDC Cable 1 (Fuse Rating: 15A @ 13.6VDC) (Power & Light Output) POWER +VDC Power Source Yellow Light Outupt #1 (Max Output Amperage @ 5A) Device #1 Orange Light Output #2 (Max Output Amperage @ 5A) Device #2 Blue... -
Page 7: Controller Function
CONTROLLER FUNCTION Light Output 1. At any moment, short press once to activate or inactivate all Light output #1 & #2 together. 2. While all light outputs are activated, long press to activate only Light output #1. 3. While only front output is activated, long press again to activate only Light output #2. -
Page 8: Pa Broadcast
PA BROADCAST Handheld Mic PA Activation Press “Push-to-Talk” button on the side of the Mic to activate Clip-on Mic PA broadcasting. PA broadcasting will override all current Siren Tone. Action will resume when PTT is released. Mic Volume Adjustment Knob Mic Volume (available on selected mic model only) Adjustment Knob...