Download Print this page

Honeywell NPB-ZWAVE Installation Instructions page 2

Option card

Advertisement

NPB-ZWAVE OPTION CARD
MOUNTING
WARNING
Power to the controller must be OFF when
installing or removing option cards, or damage
will occur! Also, you must be very careful to plug
any option card into its connector properly (pins
aligned).
Mount the NPB-ZWAVE option card in either of the option
card slots of the controller, as needed. Note the WEB/CP-202/
602-XPR series has only one option card slot.
Mounting NPB-ZWAVE option card.
1. Remove power from the WEB/CP Controller—see
the previous Warning.
Remove the JACE cover
2.
.
602-XPR)
For all but the WEB/CP-202/602-XPR, press in the
BATTERY ASSEMBLY
(INCLUDES
CABLE AND
BRACKET)
TIE WRAP
LOCK
(SEE NOTE)
BLANKING END PLATE
NOTE: The tie wrap on the battery pack should have its lock
"knot" on top, as shown in Figure 2.
If not, cut and remove the tie, then re-install another
tie wrap with its lock tab on top.
(Tie lock at bottom interferes with option card).
If a WEB/CP-201/600-XPR or
4.
remove the option slot blanking plate, retaining the
two screws.
62-0349-01
or covers (WEB/CP-202/
SCREWS (4)
OPTION SLOT 1 AREA
Fig. 2. Remove screws and battery assembly
,
WEB/CP-700
four tabs on both ends of the unit, and lift the cover
off.
If a WEB/CP-202/602-XPR, first remove the right
cover, then the left cover, retaining the two screws that
secure each cover.
NOTE: If accessory modules are plugged into the controller,
you may need to slide them away from the unit to get
to the cover tabs.
If a WEB/CP-202/602-XPR series, remove the bat-
3.
tery and bracket assembly by taking out the
screws holding it in place, setting screws aside for
later.
Figure 2 shows an exploded view of a WEB/CP-600.
UNPLUG BATTERY HERE
WEB/CP-600
NOTE: Slot 2 option card installation in a
controller requires careful attention! See its Mounting
and Wiring Guide for more details. This document
focuses on installation in a WEB/CP-201/600 series
controller.
5. Remove the blanking end plate for the slot you are
installing the option card into.
(Retain the blanking end plate in case the option card
must be removed at a later date.)
2
OPTION SLOT 2 AREA
M32454
WEB/CP-700

Advertisement

loading