Carefully remove the system from its shipping carton and inspect it for any signs of damage. Any damage should be reported immediately to the carrier. Refer to the list of supplied parts below and compare to the contents. Report any missing parts promptly to the Loctite customer service department at 1-800-LOCTITE or 1-800-562-8483.
Loctite recommends that you test all adhesive applications under simulated or actual end-use conditions to ensure that the adhesive meets or exceeds all required product specifications. Refer to the Loctite Light Cure Selector Guide or product Technical Data Sheets for curing specifications and performance.
Installation Utility and Space Requirements Electrical: 115 VAC, 5 amps, 60 Hz. Overall Dimensions: 17.27 inches high x 9.88 inches wide x 5.88 inches deep. Installing the UV Bulb Lamp should be handled only when cool and with clean cotton gloves. Do Not touch the lamp with bare hands.
Lamp should be replaced as required (follow instructions in Section 3.2. It is recommended that the lamp be monitored regularly with a radiometer to insure that the product is being completely cured. The Loctite ® Zeta ®...
In the event of unauthorized modification of the Products including, where products, parts or attachments for use in connection with the Products are available from Loctite, the use of products, parts or attachments which are not manufactured by Loctite, no claim shall be allowed.
Need help?
Do you have a question about the Zeta 7500 and is the answer not in the manual?
Questions and answers