Table of Contents
Advertisement
Installation
Pressure Sensor location
The Pressure Sensor should be installed somewhere in the first half of Drinker Line in the brood area.
Installation
Locate the control in a convenient location where it can easily be seen and adjusted.
Fasten the control to the wall through the four holes in the corners (mounting hardware not supplied)
Mounting Hole Locations
7
Not more than 1/2 system length
Figure 3.Pressure Sensor Location
30-15/16" [78.6 cm]
15-5/8" [39.6 cm]
13-1/2" [33.7 cm]
Figure 4.Mounting orientation
Chore-Tronics® 3 Auto Adjust PDS™ 4, 8, & 16 Station
(56120)
Pressure Sensor
MW2467A
Advertisement
Table of Contents
Need help?
Do you have a question about the Chore-Tronics 3 Auto Adjust PDS 4 Station and is the answer not in the manual?