Installation Steps - AT&T PagePac Plus Installation And Use Manual

Installation Steps

NOTE: The numbers in these
steps match the numbers in
figure 1-1.
1-4
O v e r v i e w
1.
Determine PagePac Plus features to be used in the facility. Refer to
the Zone Map and Zone Configuration Tables filled out in the
Programmer's Guide.
2. Verify Zone Map information matches facility wiring diagram.
3. Pull cables.
4. Mount the PagePac Plus components [Amplicenter, Controller and
Zone Expansion Unit(s)], to either the wall, cabinet or a rack.
5. Make the connection between the Controller and Amplicenter, and
Controller and Zone Expansion Unit (if any).
6. Set the DIP switches on the Zone Expansion Unit(s) [if needed].
7. Using the Zone Configuration Table, set the Zone Option Switches
on the Controller and the Zone Expansion Unit(s) to the correct
settings.
8. Set the Controllers Telephone Mode Selection Switch to the correct
position for the host telephone system.
9. If the system is used in the Constant Voltage Distribution Mode (i.e.
70 volt speakers), make connection and set the Amplicenter
Telephone Mode Selection Switch to the Dry Loop 600 Ohm position.
10. Connect all necessary feature inputs (microphone, night bell, etc.,).
11. Using the Zone Map Table, connect speakers, remote amps and
inputs to the proper zones.
12. Power up the system.
13. Check LED's on PagePac Plus system for proper operation.
14. Make the telephone connection.
15. Perform Programming.
16. Test system:
A – Audio paging Zones
B – Contact Closure Output Zones
C – Contact Closure Input Zones.