Table of Contents
Advertisement
Quick Links
OPERATING MANUAL
S.M.D. REWORK STATION
Thank you for choosing XYTRONIC LF-852DII S.M.D. Rework Station. This tool is
specially designed for soldering, desoldering Surface Mount Devices with
temperature controlled hot air. When used in conjunction with our 628 Preheat system,
the 852DII will achieve marked improvements in quality and efficiency of your
rework tasks.
Please read the operating manual carefully to maximize the advantages of using your
new LF-852DII Hot Air rework station and keep this manual readily accessible for
future reference.
FOR
LF-852DII
HOT-AIR
1
Advertisement
Table of Contents
Related Manuals for Xytronic LF-852DII
Summary of Contents for Xytronic LF-852DII
- Page 1 852DII will achieve marked improvements in quality and efficiency of your rework tasks. Please read the operating manual carefully to maximize the advantages of using your new LF-852DII Hot Air rework station and keep this manual readily accessible for future reference.
- Page 2 INTRODUCTION This appliance is not intended for use by children or other persons without assistance or supervision if their physical, sensory or mental capabilities prevent them from using it safely. Children should be supervised to ensure that they do not play with appliance.
- Page 3 3. Do not bump, hit, pour water/liquids or otherwise subject the heating surface to physical shock. This may damage the heater. 4. To isolate the equipment from the mains before commencing repairs or making any maintenance to avoid electric shock. This may result in Death or serious injury. 5.
-
Page 4: Product Features
faulty, discontinue using immediately. To comply with safety standards, the pump or other part must only be replaced by authorized technicians as special purpose tools are required. Only the technician is permitted undertake repairs. Use the original replacement part only. ●... -
Page 5: Product Description
PRODUCT DESCRIPTION The temperature controlled Hot-Air LF-852DII SMD rework station built in an intelligent microcomputer chip which is specially designed for the present lead free SMD chips such as SOIC, CHIP, QFP, PLCC, BGA etc reworks to meet RoHS requirement. This appliance equipped with a high power heating element and gets very fast heat up time. -
Page 6: Operating Precautions
OPERATING PRECAUTIONS 1. Make sure both heater and nozzle are cool before attaching the nozzle. Caution High Temperature Operation Do not use the LF- 852DII near ignitable gases, or other inflammable materials. Both nozzle and hot air are extremely hot and can cause burns. Never touch the nozzle and heater assembly or allow the hot air to blow against your skin. -
Page 7: Function Introduction
Caution: Check carefully for any damage during transportation and ensure that the working voltage matches your power supply before plugging in the station. 1. Ensure that the base unit power switch is in the “OFF” position. 2. Plug in AC power cord and turn “Mains power switch” to “ON” position then the temperature LED and wind LED display will be ON and show the value. - Page 8 When temperature display window shows "F-2" and blinking, press the "SET" button, at this time, the system enters the degrees Fahrenheit and Centigrade temperature selection function, indicating the temperature of the window shows the current status. Press "▲" or "▼" key to change the temperature selection status.
- Page 9 Note: After the power switch off about one minute later, the temperature will fall down to 75℃ (167℉) and power automatically shut off. 5. Remove any remaining solder: After removing the IC, cleaning the remaining solder chips with a wick or desoldering tool. Note: For SOP, PLCC etc.
-
Page 10: Spare Part
SPARE PART Part No. 79-410312 Heating element 120Vac,60Hz,1000W Part No.79-510312 Heating element 230Vac,50Hz,1000W ACCESSORY...