Installation - Quick TCD 1062 Manual For Use And Installation

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 12

INSTALLATION

EN
INSTALLATION OF THE TCD 1062
The TCD 1062 complies with EMC standards (electromagnetic compatibility) but requires correct installation to avoid
compromising its performance and that of the surronding instruments.
For this reason the TCD 1062 must be positioned at a distance of at least:
• 25 cm away from the compass.
• 50 cm away from any radio receivers.
• 1 m away from any radio transmitters (except for SSB).
• 2 m away from any radio transmitters SSB.
• 2 m away from the path of the radar beam.
After choosing where to position the TCD 1062, proceed as follows:
• Position the drilling template (provided) on the surface where the TCD 1062 will be installed.
• Mark the centre of each hole.
• Make the slot to house the back of the remote control.
• Remove the template and any burrs present in the holes.
• Insert the TCD 1062 into its seat.
• Fix the TCD 1062 to the panel with four countersunk head screws (not provided).
• Position the frame on the TCD 1062.
13
TCD 1062 - REV002A

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents