Table of Contents
Advertisement
Quick Links
Lumina LED and
Lumina Hybrid
controller
RJ12 Port
Step 1:
Select the light fixture
control system pressing
the selection mode button
BLAU
aquaristic
2, 3, 4 Operating LED indicator
2- Aquaristic computer control
2
3- Manual controller
4- Computer control
3
Manual dimming knobs
4
Mini USB port
To connect computer
for fixture programming
quick guide
RJ12 Port
Connect here an aquaristic computer
Dimming system 1-10v.
Port distribution
Get the software Lumina Led Controller at www.blau-aquaristic.com
Connect the light fixture to your computer by USB connector
Turn on the light and open the software
Install the lastest Firmware (Main Menu: Tools)
Program you light fixture with many light effects
Load the program to your light
Disconnect the light from the computer
Enjoy your aquarium!
1-12V
2-channel1
3-ground
4-free
5-channel 2
6-free
Turn knob with an
screwdriver
2 dimming channels
2012
Barcelona Marine Farm S.L.
Advertisement
Table of Contents
Summary of Contents for BLAU aquaristic Lumina LED
- Page 1 Select the light fixture control system pressing the selection mode button Get the software Lumina Led Controller at www.blau-aquaristic.com Connect the light fixture to your computer by USB connector Turn on the light and open the software Install the lastest Firmware (Main Menu: Tools)
- Page 2 Send your program to the light fixture before disconnecting it of the computer Use the date system or change Lumina Led Controller it. You can use too to simulate the light curve along the year before to decide the definitive...
- Page 3 Send your program to the light fixture before disconnecting it of the computer Use the date system or change Lumina Led Controller it. You can use too to simulate the light curve along the year before to decide the definitive...
- Page 4 BLAU quick guide aquaristic Test Mode will help you to see if all is working correctly. Lumina Led Controller In this mode you can do color combinations manually that later you can use for program the fixture. Test Mode Moving up and down the sliders...
- Page 5 To Save configurations or use old saved General View ones. With the Status you will know what is going Configuration in your Lumina Led To configure the program. First of all enable the different channels of your light fixture or disable the freatures that don’t correspond.
Need help?
Do you have a question about the Lumina LED and is the answer not in the manual?
Questions and answers