1. Manuals
  2. Brands
  3. Sigma Manuals
  4. Timer
  5. STPS 3000
  6. Operation manual

Sigma STPS 3000 Operation Manual

Hide thumbs
1
2
3

Advertisement

Table of Contents

Sigma Technologies
3 Sequential Timer with Pressure Switch
A.

Programming the STPS 3000

1.
Use the Key provided for turning on the program "lock". The Program mode is
indicated by a Program LED (Light Emitting Diode) turning on.
2.
Now that we are in program mode Use the Key called "Select" by pressing it and the
four LEDs on the right turn on and flash Sequentially.
3.
There are Four values to be programmed Timer 1 (Indicated by LED under Timer
Clock and Marked 1), Timer2, Timer3 and CCS.
4.
To program Timer 1 use select key to make the LED of Timer 1 Flash use Keys
marked "up" and "Down"
Start/Enter key to sore value in the Memory.
5.
Repeat same method for Timer 2, 3 and CCS.
6.
Verify Values stored by using select key to scroll the four settings.
7.
Turn the program key to turn off the program LED and remove key and place in
secure place now the settings are tamper proof.
Page 1 of 3
to make display read value required then press
5 5. 6
Lock
Select
1
Up
Down
Operation Manual
Hold
Program
2
3
CCS
Start/Enter
Reset
STPS 3000

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the STPS 3000 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Sigma STPS 3000

  • Page 1 Operation Manual 3 Sequential Timer with Pressure Switch STPS 3000 Programming the STPS 3000 Use the Key provided for turning on the program “lock”. The Program mode is indicated by a Program LED (Light Emitting Diode) turning on. Now that we are in program mode Use the Key called “Select” by pressing it and the four LEDs on the right turn on and flash Sequentially.
  • Page 2 Operation Manual Running STPS 3000 To run or operate the STPS 3000 the program LED should be off and the programming completed as explained in Page 1. Use the remote START input or the Start key on the front panel to start operation.
  • Page 3 Sigma Technologies Operation Manual Rear Panel and Relay Box Terminations. This relay is CCS Fail Relay. Time 1. This Turns on when Start Key is pressed. Time 2. This Turns on at the end of Time 1 Time 3. This Turns on at the end of Time 2.

Table of Contents