Digitech Audio Visual CW-2857 User Manual

Projector Mount For Ceiling
10kg(22lbs) max.
CW-2857
User Manual
WARNING STATEMENTS

Warning

The ceiling structure must be able to load at least
equal to the maximum weight 10 kilograms (22lbs).
If not, the ceiling must be reinforced. The correct
Installation procedure by a qualified service
technician, according to installation instructions,
must persist. Failure to do so may result in serious
injury or death, and even death.
Safety measures must be practiced at all times
during the installation of this product. Use proper
safety gear and tools for the installation procedure
to prevent personal injury.
Prior to the installation of this product, the
installation instructions should be read and
completely understood. The installation instructions
must be read to prevent personal injury and
property damage. Keep these
instructions in an easily accessible location for
future reference.
A secure structure must support the weight or load
of the display, When mounting to a wall that
contains wooden studs, dead center of the wooden
stud must be confirmed prior to installation.
Do not install on a structure that is prone to
vibration, movement or chance of impact. Failure
to do so could result in damage to the display
and/or damage to the mounting surface.
Do not install near heater, fireplace, direct sunlight,
air conditioning or any other source of direct heat
energy. Failure to do so may result in damage to
the display and could increase the risk of fire.
At least two qualified people should perform the
installation procedure. Injury and/or damage can
result from dropping or mishandling the display.
Recommended mounting surfaces: wooden studs
and solid-flat concrete. If the mount is to be
installed on any surface other than wooden studs,
use suitable hardware (which is commercially
available).
TOOLS REQUIRED NOT INCLUDED
installation
?