Summary of Contents for FIVE OCEANS PACIFIC WINDLASS Series
- Page 1 PACIFIC WINDLASS SERIES O W N E R M A N U A L 6 0 0 | 9 0 0 | 1 0 0 0 | 1 5 0 0 M O T O R S SAVE THESE INSTRUCTIONS Important safety instructions are included in this manual.
-
Page 2: Table Of Contents
TABLE OF CONTENTS Introduction Specifications Protection Notice Fitting Electrical Installation Basic Requirements Accessories Fitting the Windlass to the Deck Electrical Wiring Electric Cable Selection Wiring Control Switch Installation Wiring Diagram Operation Manual Control Power Down/Up Windlass Operating Procedures Servicing Servicing Schedule Troubleshooting Warranty Product Guide... -
Page 3: Introduction
1- Introduction Thank you for choosing Five Oceans. Five Oceans products are world renowned for their quality, technical innovation and proven performance. With a Five Oceans product you will be provided with many years of out- standing service. Product Support Five Oceans products are supported by a network of distributors and Au- thorized Service Representatives. - Page 4 Electric Specifications NORMAL WORKING MAXIMUM CURRENT LOAD LIMIT PULL DROP SPEED DRAW MOTOR MODEL m/min. Watt ft/min. Voltage Pacific 600 Pacific 900 1450 Pacific 1000 1650 1000 Pacific 1500 1500 1200 2640 1067 Dimensions Diagram Pacific 600 & Pacific 900 VERTICAL WINDLASS MANUAL VOLUME ONE...
- Page 5 Pacific 1000 & Pacific 1500 FIVE OCEANS PACIFIC SERIES...
-
Page 6: Protection Notice
• Five Oceans windlasses are designed and supplied for anchor control in marine applica- tions and are not to be used in conjunction with any other use. •... -
Page 7: Fitting
Pacific 1000 5/16" 2 3/32" 2 9/16" Pacific 1500 5/16" 2 9/16" 2 13/32" HOLE SAW SM WIRING INSTALLATION • Crimping Pliers / Wire Stripper • Suitable electrical cable and crimp terminals HOLE SAW LG DRILL HOLE FIVE OCEANS PACIFIC SERIES... -
Page 8: Accessories
4.2 Accessories Use only genuine Five Oceans parts and accessories to ensure top performance and eliminate the risk of voiding your warranty. For replacement parts, please visit your dealer or www.five-oceans.com 4.3 Fitting The Windlass to the Deck 4.3-1 If the deck is not flat, a suitable mounting pad may be required to take up camber or sheer. - Page 9 Pass all the studs through the deck and fit them security on the motor piece which is on the underside of the deck and secure the unit with the fixings provided. FIVE OCEANS PACIFIC SERIES...
-
Page 10: Electrical Wiring
5- Electrical wiring 5.1 Electric cable selection Five Oceans recommends the installer source and install cable that meets the requirements of the standards and regulations relevant to the installation and codes of practice. The cable table gives recommended cable sizes based on total length of cable required, from the battery, following the route of the cables. -
Page 11: Wiring Diagram
Pacific 600 & Pacific 900 5.4 Wiring Diagram Negative Wire ROCKER SWITCHES Positive Wire Main Switch ELECTRIC DECK SWITCHES FUSE Foot Up Foot Down MOTOR FUSE SOLENOID top view side view Battery 12 VDC FIVE OCEANS PACIFIC SERIES... - Page 12 Pacific 1000 & Pacific 1500 5.4 Wiring Diagram Negative Wire ROCKER SWITCHES Positive Wire Main Switch ELECTRIC DECK SWITCHES FUSE Foot Up Foot Down MOTOR FUSE SOLENOID top view side view Battery 12 VDC VERTICAL WINDLASS MANUAL VOLUME ONE...
-
Page 13: Operation
Turn off all power to motor windlass and release any anchor locks. When safe insert the Five Oceans wrench in to the capstan drive cap. Rotate clockwise to grip the gypsy and anticlockwise to free the gypsy controlling the rate of descent of the anchor. -
Page 14: Windlass Operating Procedures
6.2 Windlass Operating Procedures This is an anchor recovery device. DO NOT use the windlass to pull the boat to the anchor as it will damage the mechanism. Vessels at anchor will snub on the rode and this can cause slippage or apply excessive loads to the windlass. - Page 15 The method of joining illustrated is designed to minimize chafe between the rope and chain but as a matter of prudent seamanship the splice should be checked regularly and remade if there is any evidence of wear. FIVE OCEANS PACIFIC SERIES...
-
Page 16: Servicing
This problem is a result of not securing the anchor rode combined with the gypsy drive cap being slack. Tighten the gypsy drive cap using the Five Oceans wrench and always secure the anchor rode independently of the windlass when not in use. -
Page 17: Warranty
9 - Warranty All Five Oceans® products sold by Baron USA, LLC or any of the product resellers is war- ranted to be free from defects in material and workmanship from date of purchase. 1. PRODUCT: Windlass Series (Altantic & Pacific) 2. - Page 18 Use of parts that are not original Five Oceans 6. LIMITS OF IMPLIED WARRANTY AND CONSEQUENTIAL DAMAGE: Baron USA, LLC or any of the product resellers disclaims any obligation to cover any loss of time, use of this product, freight, or any incidental or consequential claim by anyone from using this product.
-
Page 19: Product Guide
(Product Number: 72) For more info click here. • Stainless Steel Self-Lauch Anchor Roller (Product Number: 3696) For more info click here. • Stainless Steel Hinged Anchor Roller (Product Number: 4184) For more info click here. FIVE OCEANS PACIFIC SERIES... - Page 20 www.five-oceans.com VOLUME ONE © Copyright 2019 Baron USA, LLC All rights reserved...