Shure A96F User Manual

MODEL A96F LINE MATCHING TRANSFORMER

This transformer connects microphones with an XLR-type connector
to the 3.5 mm (1/8 in.) inputs found on camcorders and other recording
devices. It increases the signal level from the microphone, provides a
balanced input, and prevents distortion due to the d.c. bias typically
found in camcorder microphone inputs.

IMPEDANCE SELECTION

The A96F can be modified for microphones rated at 150 Ω. This
modification is only necessary if the output level from the A96F is
insufficient for your recording device. Use the following steps:
1. Access the wiring in the XLR plug element of the A96F by loosen-
ing the screw and sliding the plug from the case.
2. Unsolder the RED lead from pin 2. Insulate the bare wire at the end
of the lead with the insulator from the YELLOW lead.
3. Solder the YELLOW lead to pin 2.
4. Rotate the plug element three turns to twist the leads and replace
the element in the housing. Replace the screw.
©2005, Shure Incorporated
27D2991 (Rev. 4)
Model A96F
User Guide
Printed in U.S.A.