Advertisement
6. OPERATION
6.1.
USING THE WHEEL CHANGER TO REMOVE A WHEEL Refer to fig.2
6.1.1.
Position the vehicle on a suitable horizontal floor and apply the brake.
6.1.2.
Jack up the axle of the wheel to be changed with a suitable jack, so that it is clear of the floor. Secure with axle stands.
6.1.3.
Press down the lowering pedal (A).
6.1.4.
Pump the wheel changer apart with the pump lever (C).
6.1.5.
Adjust the wheel support (D) so that the clamp support arm (E) is positioned over the wheel to be handled.
6.1.6.
Push the wheel changer unit under the wheel so that the roller tables are positioned either side of the wheel and that the wheel sits
up against wheel support (D).
6.1.7.
Check that the lowering pedal (A) is in its uppermost position. Pump the unit together until the wheel and the unit cannot glide
apart.
6.1.8.
Lower the clamp support arm (E) behind the wheel and adjust until the wheel is vertical and can be moved approximately 5cm
sideways. This will allow the wheel to be rotated in the wheel changer when relocating wheel studs. Lock the clamp support arm in
position by tightening adjustment clamps (I and J).
Note: the angle of the wheel supports can be adjusted by the removal of pin (H) to accommodate different wheel configurations,
see fig.2.B.
WARNING! Wheel support (D) and clamp support arm (E) are only used to balance the wheel NOT to carry a load!
ˆ
6.1.9.
Lift the wheel by pumping the lever (C). When the wheel is positioned on the unit the wheel changer must be secured in the lifting
position with the locking mechanism (F).
▲
IMPORTANT: Ensure that the locking mechanism (F) is secured through the nearest location hole on the inner member. This
prevents unintentional lowering of the wheel while it is being handled.
6.1.10.
With the wheel nuts removed the wheel can now be safely carried away on the wheel changer.
6.1.11.
Put pump lever (C) into socket (K). Use with handle (L) to push the wheel changer.
6.2.
UNLOADING THE WHEEL CHANGER Refer to fig.2.
6.2.1.
When the wheel is located on the wheel studs and secured with the wheel nuts or the wheel has been moved to a place for
storage, the wheel can be released.
6.2.2.
Loosen clamp support (E) by releasing adjustment clamps (I and J).
6.2.3.
Lift and release locking mechanism (F).
6.2.4.
Press down the lowering pedal (A). Pump apart the wheel changer with the pump lever (C).
6.2.5.
Adjust the wheel support arm (E) so that it does not catch on the top of the wheel before manoeuvring the wheel changer clear of
the wheel.
6.2.6.
6.2.7.
6.2.8.
6.2.9.
6.2.10.
6.2.11.
6.2.12.
6.2.13.
6.2.14.
6.2.15.
6.2.16.
6.2.17.
6.2.18.
6.2.19.
6.2.20.
6.2.21.
6.2.22.
6.2.23.
6.2.24.
6.2.25.
6.2.26.
6.2.27.
6.2.28.
6.2.29.
6.2.30.
6.2.31.
6.2.32.
© Jack Sealey Limited
Original Language Version
Fig.2
W1200T.V2| Issue 3(I) 23/08/16
Advertisement
