CenturyLink WF-802G Installation Manual

Wi-Fi Extender Installation Guide

Your kit should include:

•
Device Model Number WF-802G
•
Device Model Number WF-802GW
•
Yellow Ethernet Cable
Note: once you get started, you will have two minutes to complete Steps 1 – 3.

Step 1

Near your high-speed internet modem, find an electrical power outlet that is not
controlled by a wall switch. Plug Device Model Number WF-802G into that outlet.

Step 2

Plug one end of the yellow Ethernet cable into the Ethernet port on the bottom of
Device Model Number WF-802G. Plug the other end of the yellow Ethernet cable into
any one of the Ethernet ports on your high-speed internet modem.

Step 3

Find another, nearby, electrical power outlet that is not controlled by a wall switch.
Plug Device Model Number WF-802GW into that outlet.

Step 4

Device WF-802GW should begin to auto-pair with Device WF-802G. The LED next to
the house icon
devices. Auto-pairing can take up to 4 minutes. When auto-pairing is completed, the
LED should be solid green on both devices.

Step 5

Unplug Device WF-802GW and move it to a room where you would like extended
Wi-Fi coverage. Plug Device Model Number WF-802GW into an electrical power
outlet that is not controlled by a wall switch. Your setup should look similar to the
pictures on page 2, and you are ready to enjoy extended Wi-Fi coverage.
Additional help is available if needed at
www.centurylink.com/chat
should be blinking green during auto-pairing on both