Advertisement
Quick Links
Advertisement
Summary of Contents for Mita WP3000
- Page 1 Configuration Mita WP3000...
-
Page 2: Table Of Contents
RS 232 communication 1. Table of contents Table of contents ........................... 2 Introduction ........................... 3 Mita - WP3000 ..........................4 Cables ............................6 4.1. WP3000 ..........................6 Four Faith F2403 GPRS Signal monitoring ................. 7 PS-Data April 29 2013 Page 2... -
Page 3: Introduction
RS 232 communication 2. Introduction This document shows how to enable RS232 communication on a WP3000 controller. The document includes: • How to change parameter and which settings needs to be changed. • Hardware updates and changes. • What new hardware is needed. -
Page 4: Mita - Wp3000
• Modem handling • Id number Normally is all communication done via com4 and the default setting is 9600 Baud. A WP3000 always uses 8 data bits, no parity and 1 stop bit (8N1) To be able to change parameter is it necessarily to login. - Page 5 RS 232 communication • Service menu • DataLog ctrl • Ser.# menu • Access list • Event list • Status count • Status list • Parameters o Communication control Baudrate Com1 Baudrate Com2 Baudrate Com3 Baudrate Com4 9600 (Can be between 1200 and 57600) WP3033 Com1 WP3033 Com2 Com 5 not installed...
-
Page 6: Cables
RS 232 communication 4. Cables 4.1. WP3000 Four-Faith WP3000 DB9 Female DB9 Female Same as the standard Four-Faith (Black) communication cable. PS-Data April 29 2013 Page 6... -
Page 7: Four Faith F2403 Gprs Signal Monitoring
RS 232 communication 5. Four Faith F2403 GPRS Signal monitoring The Four Faith F2403 GPRS modem can be used to monitor the signal strength during installation. This can be done on units bought after October 2014 and with firmware versions after this date. The Signal mode is activated using a special DB9 adaptor that is inserted into the RS232 port on the Four Faith modem.