Summary of Contents for Franklin Fueling Systems FE PETRO PMA 75
- Page 1 Pump Motor Assembly Replacement Instructions ©2013 400289002 Rev. 9 Franklin Fueling Systems • 3760 Marsh Rd. • Madison WI 53718 USA Tel: +1 608 838 8786 • 800 225 9787 • Fax: +1 608 838 6433 • www.franklinfueling.com...
- Page 2 Important Safety Messages FE Petro equipment is designed to be installed in association with volatile hydrocarbon liquids such as gasoline and diesel fuel. Installing or working on this equipment means working in an environment in which these highly flammable liquids may be present. Working in such a hazardous environment presents a risk of severe injury or death if these instructions and standard industry practices are not followed.
- Page 3 Procedure Disconnect power to the submersible pump at the electrical supply box. Tag and lock out electrical circuit breakers so they are not turned on accidentally. Note: See Figure 1 to identify the particulars of a STP. Loosen the two junction box mounting bolts, but don’t remove them. This will make disconnecting the wire connector assembly easier.
- Page 4 24. If any leaks are observed, line pressure isn’t correct, or any other problems or concerns occur, call FFS Technical Support at 1-800-225-9787. 25. Fill out the Warranty Registration Card and return it to Franklin Fueling Systems. Note: If a STP or an IST does not operate correctly or there are any questions concerning installation or service, please contact FFS Technical Services at (800) 225-9787.
Need help?
Do you have a question about the FE PETRO PMA 75 and is the answer not in the manual?
Questions and answers