Maddox MH5-1 Owner's Manual & Safety Instructions page 3

Cylinder leak-down tester
Table of Contents

Advertisement

13. Stay alert. Watch what you are
doing, use common sense. Do not
operate any tool when you are tired.
14. Replacement parts and accessories.
When servicing, use only identical
replacement parts. Use of any
other parts will void the warranty.
15. Do not operate tool if under the
influence of alcohol or drugs.
Read warning labels on prescriptions to
determine if your judgment or reflexes
are impaired while taking drugs. If there
is any doubt, do not operate the tool.
16. Maintenance. For your safety, service
and maintenance should be performed
regularly by a qualified technician.
SAVE THESE INSTRUCTIONS.
About Cylinder Leak Testing
A Cylinder Leak-Down Tester can give
you valuable information about the
engine's compression. Pressurized air
is supplied to each cylinder, and the
rate of leakage is measured in PSI and
converted to a percentage of loss.
The operator may also locate the
source of the compression loss
by listening at these places:
a. Oil dipstick tube for leaking
cylinder rings.
Item 64918
For technical questions, please call 1-888-866-5797.
17. People with pacemakers should
consult their physician(s) before use.
Electromagnetic fields in close proximity
to heart pacemaker could cause
pacemaker interference or pacemaker
failure. Caution is necessary when near
coil, spark plug cables, or distributor
of running engine. Engine should be
off during distributor adjustment.
18. The warnings, cautions, and instructions
discussed in this instruction manual
cannot cover all possible conditions
and situations that may occur. It must
be understood by the operator that
common sense and caution are factors
which cannot be built into this product,
but must be supplied by the operator.
b. Radiator fill cap for
cylinder wall cracks.
c. Adjacent port for head
gasket leaking.
d. Tailpipe for exhaust valve leaks.
e. Carburetor air horn for
intake valve leakage.
f. Fuel injector body for
intake valve leakage.
If you are not experienced in doing this
type of diagnostic test, the work should
be done by a qualified technician.
Page 3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents