Summary of Contents for Full Speed TinyLeader
- Page 1 FullSpeed TinyLeader Brushless Whoop FullSpeed TinyLeader Brushless Whoop (HD record version) Qucick set up manual 25mW-600mW VTX FPV Transmitter set up: (please unlock the VTX if set up through OSD) 全速电子 http://www.fullspeedrc.com/ 第 1 页...
- Page 2 FullSpeed TinyLeader Brushless Whoop Binding FLYSKY receiver: 1. Press and hold the key on the receiver and connect the power to the receiver. The green indicator light on the receiver indicates that the frequency is entered. 2, the remote control into the frequency of the state; the frequency 全速电子...
- Page 3 FullSpeed TinyLeader Brushless Whoop into the receiver status indicator from the rapid flash to slow flash. 3, the remote control manually out of the frequency interface, then the receiver green light becomes bright. Indicates that the signal receiver is successful.
- Page 4 FullSpeed TinyLeader Brushless Whoop FRSKY receiver: 1. Select D8 mode on Frsky remote control. Hold the bind key on Frsky-Nano receiver and connect the battery, then the receiver's red light will be always on. 2. Select the BIND mode on remote control , the Frsky-Nano receiver's blue light will flash slowly and the red light will be always on which means bind complete.
- Page 5 FullSpeed TinyLeader Brushless Whoop Caddx Turtle V2 Quick operation guide 1. RIGHT BUTTON Press the RIGHT button for 3s-5s to activate video recording, in the meanwhile the light on the lower right corner will flicker. 2. LEFT BUTTON Press the LEFT button for 3s-5s to stop video recording.
- Page 6 FullSpeed TinyLeader Brushless Whoop 全速电子 http://www.fullspeedrc.com/ 第 6 页...
Need help?
Do you have a question about the TinyLeader and is the answer not in the manual?
Questions and answers