Cleaning And Maintenance; Ecology - Environment Protection; After Operation - PROFILO PEI0800B User Manual

Start-up
●
Set the thermostat (4) for desired temperature
("I" to "V").
"I" = the lowest temperature.
"V" = the highest temperature.
During warming up the pilot light (5) glows. When the
appliance reaches the set temperature, the light goes off and
the heater shall switch off. The grill heat up from time to time,
in order to keep the set temperature.
During first usage, the preserving materials
shall be burnt which can cause short emission
of unpleasant smell at the initial stage of
grilling.
It is not allowed to move the hot appliance
during operation! At first switch off and wait
until it cools down. Move with heat-resistant
handles only.
Operation guidelines
●
It is recommended to wipe the surface with edible oil
before grilling products in order to improve the non-
sticking properties.
●
The grilling plate (1) is perfect for preparing eggs, ham,
tomatoes, onion, etc. It is also excellent for keeping the
dishes warm.
●
The 3–4 level is recommended in order to obtain uniform
grilling.
●
Heat the grill before putting the products on (unless the
receipt requires otherwise).
●
When preparing tender dishes (i.e. fish) after applying
spices you can wrap it with aluminium foil.
●
Soft pieces of meat are the best for grilling.
●
You can marinate meat in advance, to make it tenderer.
●
Use special tongs or spatula for turning products on grill,
it is not allowed to use pointer forks.
●
Do not turn the grilled products to often. In case they get
brown on both sides, finish grilling at lower temperature.
Thanks to it the products shall not get dry and they shall
be uniformly grilled.
●
In case the products are not instantly consumed, you can
keep them warm with 1 level setting.
It is not allowed to cut the products on the grill,
in order to prevent the damages of non- stick
layer.

After operation

●
Set the thermostat in "OFF" position in order to switch off
the appliance.
●
Always disconnect form mains after usage. Let the
appliance cool down before disassembling and
cleaning.
PEI0800B-001_v01

Cleaning and maintenance

●
Wash and wipe thoroughly all parts before storage.
●
Make sure that the plug and heating plate is dry
before connecting the thermostat to the heating plate.
If necessary, wipe thoroughly with dry cloth and leave for
drying for a while.
Thermostat
●
On no account allow the water get inside the thermostat!
Do not clean under running water and do not immerse!
Clean the thermostat with damp cloth only.
Heating plate
●
It is forbidden to use caustic cleaning agents, scourers
with scouring agents, wire wool, etc., as they can
damage non-stick surface.
●
Remove severe dirt with damp cloth. Use a soft bottle
brush for cleaning the grill.
Grease drip tray
●
Clean the grease drip tray with damp cloth or under
running water.
The appliance is not intended for being washed
in dishwashers!
Ecology – Environment protection
Each user can protect the natural environment. It is neither
difficult nor expensive.
In order to do it: put the cardboard packing
into recycling paper container; put the
polyethylene (PE) bags into container for
plastic.
When worn out, dispose the appliance to
particular disposal centre, because of the
dangerous elements of this appliance, which
can be hazardous for natural environment.
Do not dispose into the domestic waste disposal!
The importer/manufacturer does not accept any liability for any
damages resulting from unintended use or improper handling.
The importer/manufacturer reserves his rights to modify the product
any time in order to adjust it to law regulations, norms, directives,
or due to construction, trade, aesthetic or other reasons, without
notifying in advance.
9