Seashell SS-1 User Manual

Customized waterproof camera housing

Advertisement

SS-1
Customized Waterproof
Camera Housing
User Manual
Page 1
Page 2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SS-1 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Seashell SS-1

  • Page 1 SS-1 Customized Waterproof Camera Housing User Manual Page 1 Page 2...
  • Page 2: Table Of Contents

    • Unpacking.....................3 • Attention!....................6 • Configuring a Seashell ................7 • Ensuring the Seashell fits the Camera.............8 • Installing the Dove Tail Shims & Actuator Shafts........9-12 • Attaching the Back Foam Pad onto the Rear Housing ......13 • Water Leakage ..................14 •...
  • Page 3: Introduction

    131 foot depth. A few minutes are all that required for customizing the Seashell to your camera. Please carefully follow this manual to set up the Seashell, so one may enjoy the best results and benefit from the best protection for your camera. Before use, inspect the Seashell housing to ensure it is functional, and free from sand or dirt.
  • Page 4: Attention

    • to fit for a new camera. Avoid direct sunlight, heat or fire. • There are 6 key steps in configuring a Seashell: Do not use Seashell water proof camera housing in hot water. • Confirming the Seashell fits your camera •...
  • Page 5: Installing The Dove Tail Shims & Actuator Shafts

    • If the camera is compatible with Seashell, the camera will fit within the fitting lines with the lens reasonably near the center cross- hairs. Ideally, the Shutter and Power buttons of the camera are within the range indi- cated on the Fitting Sheet.
  • Page 6 • Use the Mini Wrench to lock the actuator shaft in place and tighten by turning a further half turn only. Note: Do not over-tighten. Over-tightening may damage the Hanging Clamp. • According to the shape and size of the shutter button, select the best Pin Pad and press it onto the tip of Actuator Shaft.
  • Page 7: Attaching The Back Foam Pad Onto The Rear Housing

    • • Put Seashell camera case on a flat surface Center the Foam Pad, wax paper up, over with the rear housing facing up, open the the back of the camera to ensure the rear housing.
  • Page 8: Maintenance Of The Seashell

    Apply one drop of o-ring grease that comes Shutter and Power button with the Seashell camera housing and • Press the shutter button of the Seashell all spread it along the whole length of the o-ring the way down. using your fingers pulling from one direction •...
  • Page 9: Preparation Of The Seashell

    Photographing • • Fasten both ends of the Neck Strap or the Press the power button to turn the camera Hand Strip to the Strap Mounts of Seashell. “On”. • • Use of the Neck strap underwater is dangerous Use the shutter to snap pictures.

Table of Contents