Table of Contents
Advertisement
4
Installation (for engineers only)
4.1
Mounting the programmer on a wall
The programmer is attached to the wall by three screws.
CAUTION: Risk of injury and damage to the casing if incorrectly mounted.
B Do not use the rear panel of the casing as a drilling template.
B Drill top fixing hole (
protruding.
B Unscrew the screw at the bottom of the programmer and remove the cover.
B Locate top slot in programmer over top screw.
B Mark bottom fixing holes (
B Align the programmer and fix in place using the left and right fixing holes at the bottom.
5 mm
Fig. 3
Mounting the programmer on a wall
1
Top fixing hole
2
Bottom fixing holes
Fig. 3, Item 1) and screw in the screw supplied leaving a length of 5 mm
Fig. 3, Item 2), drill holes and insert plugs.
1
2
6 720 644 593 (2010/04)
INSTALLATION (FOR ENGINEERS ONLY)
7747006072-01.1 SD
11
Advertisement
Table of Contents
