Main Parts Of Product; Assembly Instructions; Before Each Use - Roughneck 57141 Owner's Manual

Part No. Description
1 Hose reel
2 Inlet hose assembly (1/2"*2m)
3 Oil pump
4 Outlet hose assembly (1/2"*4)
5 Suction probes

Use only on a dry, clean, level surface capable of supporting the weight of the vehicle.

Engine exhaust contains carbon monoxide; an odorless, invisible gas that can cause injury or
death. Do not run the vehicle's engine while using this product.

Never work under a vehicle without the proper support devices. An incorrectly supported vehicle
can tilt or fall and cause injury or death.

Do not exceed the maximum rated pressure.

Do not use the pump with water or any other liquid other than oil.

Fire hazard: flame or heat sources may ignite oil resulting in fire, injury, or death. Never use or
store this product near open flames or other heat sources.

Do not use with corrosive or flammable fluids.

Not for use by or around children.

Attach the #1 hose reel to the wall with the #7 and #8 wall brackets.

Connect the #2 inlet hose assembly to the #1 hose reel suction.

Attach the #3 oil pump to the #7 wall bracket.

Install the #6 vacuum meter at the side of the #3 oil pump (holes).

Connect the #2 inlet hose assembly to the #3 oil pump bottom hitch.

Attach the #10 connector to the #1 hose reel outlet port.

Attach the #4 outlet hose assembly to the #1 hose reel draining position.

Always wear the proper personal protective gear including ANSI Z87.1 compliant safety goggles
and heat-resistant rubber gloves when using this product.

Main Parts of Product

Qty. Part No.
1 6
1 7
1 8
1 9
1 10

Assembly Instructions

⚠WARNING

Before Each Use

⚠WARNING
Page 7 of 12
Description
Vacuum meter
Wall bracket
Wall bracket
Probes container
Connector
Qty.
1
1
1
1
1