Advertisement
1 Remove the diffusor. Place simultaneously 2 flat blade screwdrivers and pull up gently the
reflector.
2 Install the included plastic cover in to the unused hole and install the base plastic (with the
included mounting screws and plugs).
3 Always use in any case round mains cable, with external diameter of 6-9mm (H05RN-F type
2x1mm² or any other type, at least equal to it's mechanical and electrical properties).
ATTENTION!! The cable must not be deformed in any way (This requirement is important to
ensure the tightness isolation IP 65). Install the cable gland, pass the round cable thru and
tighten it all the way.
4 Place the battery's connector to the corresponding connector on the P.C.B. NOTE!! If you don't
need the yellow led's to light in normal operation, then remove the led jumper.
5 Connect the mains as shown in figure (connect the ground wire if required).
6 Install the included tie (if needed) to fasten securely the power cables.
7 Refit the reflector and fasten the two small screws (included).
8 Finaly place the diffusor by using the 4 included screws (tightening torque 1.2Nm).
1
N
L
5
Mains connection
8
NOTE!! After finishing the installation you must power the luminaire at least for 24 hours for
battery charging to perform the named autonomy.
Battery replacement
1. Unfasten the 4 retaining screws (step 8 of the installation instructions) and remove the diffusor.
2. Unfasten the 2 retaining screws step 7 of the installation instructions and remove the reflector.
3. Remove the old battery and place a new on of the same type and characteristics.
4. Replace the removed parts (previous steps 1,2).
Page 2 from 2
INSTALLATION INSTRUCTIONS
2
TEST procedure with extra care!!
9 Unfasten the mounting screws (step 8) and remove the diffusor.
When the luminaire is supplied by the mains, press on the marking for
TEST as shown in the picture below. Mount the diffusor by using the 4
removed screws.
3
6
LED
JUMPER
4
7
923936010_23_008
Advertisement
