Furuno DI-FFAMP Installation Manual

Fish Finder Power Amplifier
A Word to the Owner of the DI-FFAMP
Congraturations on your choice of the FURUNO DI-FFAMP Fish Finder Power Amplifier. The DI-
FFAMP is a power amplifier designed for use with the internal fish finder of the TZtouch3 (TZT12F/
16F/19F) multi function display. Please carefully read and follow the recommended procedures
for installation and maintenance. Thank you for considering and purchasing FURUNO.

Operational cautions

• A separate power supply is required. Take the power from the ship's mains via the ship's switchboard.
• The DI-FFAMP is not turned off when the multi function display is powered off. The power amp's standby
power is 6.2 W, so turn it off when it is not in use.
• Bottom Discrimination, RezBoost and ACCU-FISH are disabled when the power amp is in use.
• The amp can be used with two in-hull transducers, R599LM/LH and R111LH. Do not transmit with the
transducer out of water, to prevent damage to the transducer.
• Use the multi function display to change the program version of the power amp. Contact FURUNO for
information on how to upgrade program version.

Safety Instructions

The installer must read the safety instructions before attempting to install the equipment.
WARNING
CAUTION
Warning, Caution
WARNING
Do not disassemble or modify the
equipment.
Fire, electrical shock or serious injury
can result.
Use the proper fuse.
Use of a wrong fuse can damage the
equipment and may cause fire.
12VDC
15 A
Pub. No. IMC-45121-A
(2002, TAYA) DI-FFAMP
Installation Manual
DI-FFAMP
Model
Indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a potentially hazardous situation which, if not avoided,
could result in minor or moderate injury.
Prohibitive Action
24VDC
10 A
www.furuno.com
Mandatory Action
CAUTION
Observe the following compass safe
distance to prevent interference to a
magnetic compass:
Standard compass Steering compass
0.3 m 0.3 m
00019714810