Advertisement

Operating Manual
Serial N° ..................

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Nano Surfox Marking and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Walter Nano Surfox Marking

  • Page 1 Operating Manual Serial N° ………………...
  • Page 2: Table Of Contents

    GB – Index Machine pictures .………….….…………………………………………………………………………………………..1. Machine features …………………….…………………………………………………………………………………… 1.1. Unit application …………………………………………………………………………………………………… 1.2. Technical datas …………………………………………………………………………………………………… 1.3. Machine components ……………………………………………………………………………………………. 1.4. Mobilization and storage of the machine ………………………………………………………………………. 1.5. Equipment ………………………………………………………………………………………………………… 2. Safety ..……………………………………………………………………………………………………………………… 2.1. Personal protective equipment ……………………………………..…………………………………………….
  • Page 5: Machine Features

    This manual is an integral part of the machine and must be kept throughout the entire service life of the same for future consultation. This manual reflects the state-of-the-art at the moment the machine was supplied and cannot be considered inadequate if there have been subsequent modifications according to further experience. (walter.com) is at your disposal to provide ALTER URFACE ECHNOLOGIES...
  • Page 6: Machine Components

    • Storage The machine must be kept in a dry and safe place, mainly to avoid damage of its electrical components. 1.5. E QUIPMENT Nr. 1 NANO SURFOX MARKING machine Nr. 20 standard felts (13a) Nr. 1 handgrip (10) Nr. 5 O-rings (14a) Nr.
  • Page 7: Safety

    The machine is constructed in compliance with established EU safety standards and bears the CE mark. The machine NANO SURFOX MARKING can be employed with a high degree of safety on condition that all safety standards, common sense, Manufacturer's instructions and established legislation are observed. It is thus essential that the safety manager makes sure that his staff read this manual before operating the machine.
  • Page 8: Battery Charger

    4. MARKING SCREEN To mark stainless steel surfaces it is necessary the use of a marking screen (15) that it is realizable on specific graphic request of customer. Please contact W walter.com to buy a personal marking screen. ALTER URFACE ECHNOLOGIES 5.
  • Page 9: Electric Installation

    7. ELECTRIC INSTALLATION Machine OFF: 1. Connect one side of the torch power cable (8) into the socket (2) situated in the front panel of the machine and the other side on top of the handgrip (10). (Picture D – Picture E) 2.
  • Page 10: Maintenance

    11. DECLARATION OF CONFORMITY: CE - R declares that the NANO SURFOX MARKING electro-chemical machine meets the ALTER URFACE...

Table of Contents