Advertisement
Advertisement
Table of Contents
Summary of Contents for Merritt Manufacturing Churchill
- Page 1 The Churchill EZ-Guard Buckle Installation Instructions Merritt Manufacturing...
- Page 2 When ordering a Churchill with the buckle guard, you will receive two buckles. One of the buckles is installed on the Churchill, with the buckle guard permanently installed. The other buckle is in the parts bag and is available should you decide to stop using the buckle guard.
- Page 3 Removal of the Existing Buckle NOTE: The following steps describe how to replace the existing buckle with an EZ- Guard buckle. 1. Disconnect the buckle from the harness (Figures B and C). 2. From the bottom of the restraint, grasp the buckle anchor, twist it 90 degrees, and insert it through its locator slot...
- Page 4 Installation of a Buckle with Buckle Guard 1. From the front side of the restraint, grasp the buckle anchor and twist it so that it can be inserted into the appropriate anchor slot (Figure A). 2. Insert the buckle anchor through the slot (Figure A);...
- Page 5 (Figure G). NOTE: Refer to the Churchill’s “Instructions for Use” Manual for complete instructions. NOTE: Do not use this product if caregiver is...
Need help?
Do you have a question about the Churchill and is the answer not in the manual?
Questions and answers