Advertisement
Activation and installation:
Activation test:
Daytime activation: after installation.
Night-time activation: after installation, press and hold the ON/OFF
button to activate by hand.
Functions of ON/OFF button:
1. When the system is switched off, press and hold the button to
activate until the lamp is on;
2. When the system is working normally, press and hold the button for
5 seconds to enter the transportation mode, until the lamp flashes for
three seconds and turn off;
3. When the system is in transportation mode, press and hold the
button for 5 seconds to switch off the system, until the lamp flash for
one second and turn off;
4. When the system is working normally, press the button without
holding to turn the lamp on/off.
When the USB is not in use, close it properly with the cap in order to avoid
damaging the controller through dampness or water.
Installation:
A licensed electrician is required to install the unit with AC power supply.
Please have a licensed electrician install this unit to avoid risk of shock damage to
luminaries. Pay close attention to the cable polarity. Tie up with waterproof rubberized
fabric after completing wiring.
Bird spike: Use 3 self-tapping screws to fix the bird spike along the rim of the top of the light.
1
(See Figure 1)
2
Install bracket. Use M8 spring washers, flat washers and M8 screws to connect them, leave
enough space to ensure the bracket can fit onto the pole.
3
Fit solar light onto pole and make sure it is securely fastened with M8 screws. (See Figure 2).
The maximum torque for those M8 bolts is 14Nm. Do not surpass this torque specification.
The product will be
damaged if the top of the
pole diameter is less
than 75mm.
5
ON/OFF button
Switch-off
Switch
Transportation
-on
Press and
hold for 5S
Figure 1
Ø75~90mm
Figure 2
Troubleshooting:
No. Symptoms
1
No light at night
mode
A serious shortage
2
of working time
Lighting does not
follow the normal
3
operating mode of
turning on and off
Lights fail to turn
4
on properly when
humans approach
Troubleshooting steps
Process
Check that the lamp can be manually
Refer to "Activation and Installation" section
activated.
on this user guide and run activation tests.
Check if the solar panel is blocked
Clear obstructions or change installation
from the sunlight by houses, trees and
location.
other obstacles.
Check if there is any artificial light
Remove the artificial light source(s) of
source(s) shining on the solar panel
interference or change the installation
during the night.
location.
Examine status of each component
Replace the damaged component(s).
based on the repair guide.
Check if the solar panel is blocked
Clear obstructions or change installation
from the sunlight by houses, trees and
location.
other obstacles.
Check if the surface of the solar panel
Clean the surface of solar panels as
is dusty or covered.
detailed above.
Examine if the battery pack is
damaged as per the repair guide
Replace damaged battery.
instructions.
Reprogram.
When the air temperature is close to human
Check if the air temperature close to
temperature, motion detection may slow
human body temperature.
down. It will return to normal after the air
temperature changes.
It is out of motion detection range when
Check if the installation height is too
installation height exceeds 8m. It is
high.
recommended to reduce the height or use
other operating modes.
Replace damaged motion sensor or
controllers.
6
Advertisement
