Getting Started - Panther Freshwater 55-0102 Installation And Operating Instructions Manual

Any angler who trolls with a kicker motor will appreciate the benefits of the Panther T‐4 Electrosteer.
Installs easily on any kicker motor that has a threaded lt‐tube, and there is no need to drill holes in your
transom. The drive unit has a rugged internal motor that steers the kicker though the use of a remote
tethered to a 24 foot cable. Simply push one of the direc onal bu ons and the T‐4 will immediately
respond, moving your kicker incrementally for precision control. For a drama c move, hold down the bu on
to quickly move your kicker from full right to le in seconds to swi ly and safely make a hard turn. The drive
unit and remote are powered by your boat's 12 volt ba ery .
NOTE: The T‐4 CANNOT be used if you have a main engine to kicker steering e bar. The main engine e
bar must be disconnected.
Please take a few moments to review the informa on contained in this booklet to familiarize yourself with
the installa on procedures of your new T‐4. Installa on is easy par cularly when you know each step
ahead of me.
Here is a list of the tools and supplies that you may need:
Tools and Equipment:
1. Electric drill with 1/8 drill bit
2. A Phillips head screw driver
3. Tube of dielectric grease for the electrical connec ons (recommended)
4. 1 1/4" Wrench or equivalent tool
5. Hacksaw
DO NOT CUT THE ROD UNTIL ALL THE DIRECTIONS HAVE BEEN
The Panther T‐4 is controlled with a push bu on switch on a 24 foot cable. It can also be controlled
using the op onal Wireless Remote [Panther part # 55‐0105], or the TrollMaster PRO3 Plus wireless
thro le and steering control [TMPRO3PLUS]. Both sold separately.
PANTHER WIRELESS REMOTE
INTRODUCTION

GETTING STARTED

READ AND YOU ARE SURE OF THE ROD LENGTH
NOTE:
TROLL MASTER PRO 3 PLUS
2