NICOR TPE Series Installation Instructions

The installation must only be performed by a licensed electrician.
To prevent death, injury or damage to property, this product must be installed in accordance to National Electrical Code (NFPA70) in the US
or Canadian Electrical Code (CSA 22.1) in Canada.
Disconnect power before installing the product or servicing it.
Wait until fixture has cooled down before installing or servicing the fixture.
MIN. 90°C SUPPLY CONDUCTORS
What's In The Box
Two (2) End Pieces
Eight (8) Screws
Turn off power to appropriate
1
circuit at the breaker box.
Carefully unpack the fixture from its packaging. Inspect product
1
for defects due to shipping.
3
Install frame onto desired location using appropriate fasteners (not provided).
NICOR, Inc. 2200 Midtown Place NE, Albuquerque, NM 87107 P: 800.821.6283 F: 800.892.8393 www.nicorlighting.com March 9, 2018 3:29 PM rev 1.0
Two (2) Side Pieces
2

INSTALLATION INSTRUCTIONS

Tools & Materials Needed
This Frame kit requires very few tools for installation. A drill or a
screwdriver and a pair of wirecutters, and appropriate fasteners
for mounting surface
*Dimensions
Assemble the Frame kit using hardware provided.
TPE Frame Kit