Advertisement
Wireless remote control, 1-gang
￭
Stopping the Venetian blind: Press the button for less than 1 second.
￭
Adjusting the Venetian blind: Press the button for less than 1 second.
If the break between the two button actuations is longer than approx. 1 second, the direc-
tion will change.
Operating push-button actuator
￭
Press the button. The load is switched on for the duration of the button-press.
The maximum actuation length is 60 seconds.
6
Information for electrically skilled persons
DANGER!
Mortal danger of electric shock.
During commissioning, cover the parts carrying voltage on radio transmitters and ac-
tuators and in their surrounding area.
6.1 Commissioning
The battery is already inserted in the state as supplied. Pull the plastic strip (Figure 2) to activ-
ate.
Changing the battery
Obey the battery safety instructions.
￭
Unscrew the battery compartment on the back of the hand-held transmitter. Use a small
flat head screwdriver or Phillips screwdriver PH1 for this.
￭
Keep contacts of batteries and device free of grease.
￭
Remove the old battery.
￭
Apply battery to the positive contact of the battery holder. Observe polarity: the positive
pole of the battery must be at the top.
￭
Press gently on battery to snap it in.
￭
Close and screw the battery compartment with max. 0.3 Nm.
Connecting to radio actuator
The Prog (Figure 3) button can be pressed with a thin wire or paper clip through the hole in the
battery cover.
32582532
10867221
Figure 2: Activating the battery
20.12.2019
3 / 7
Advertisement
