Advertisement
Quick Links
Advertisement
Summary of Contents for Nokta MAKRO EZ Wander
- Page 1 WIRELESS MODULE User Guide...
- Page 2 8. Once the pairing is complete, the EZ Wander and the detector will connect automatically at the next start-up. To turn on or off the EZ Wander, press and hold the power button for about 3 seconds. 9. To adjust the volume, use the VOLUME setting of the detector.
- Page 3 8. Once the pairing is complete, the EZ Wander and the detector will connect automatically at the next start-up. To turn on or off the EZ Wander, press and hold the power button for about 3 seconds.
- Page 4 8. Once the pairing is complete, the EZ Wander and the detector will connect automatically at the next start-up. To turn on or off the EZ Wander, press and hold the power button for about 3 seconds.
- Page 5 2. Insert your wired headphone's plug into the headphone jack located on the side of the EZ Wander. 3. Press and hold down the power button on the EZ Wander for about 7 seconds. The blue LED will flash fast while the button is pressed down. Do not let go of the button until the beep indicating the battery status is heard through the headphones and the red LED on the EZ Wander lights up.
- Page 6 (not applicable for Racer 2 and Gold Racer versions with the wireless module built-in). 3. Press and hold down the power button on the EZ Wander for about 7 seconds. The blue LED will flash fast while the button is pressed down. Do not let go of the button until the beep indicating the battery status is heard through the headphones and the red LED on the EZ Wander lights up.
-
Page 7: Technical Specifications
Charge the battery if it is low. Charging 1. You can charge the EZ Wander with a USB charger, a powerbank or on a PC or in your car using the included charging cable. The charging time may be longer for USB chargers rated less than 1 Amp or older type of PCs. - Page 8 www.noktadetectors.com...