Coopers 9765 Instructions

Big Digit R/C Alarm Clock

BEFORE USE

Remove the battery compartment cover.
Insert 1x AA battery, observing correct
polarity as indicated in the battery
compartment. Replace the battery
compartment cover.

SETTING THE CLOCK

The clock automatically sets itself to 12 O'clock and searches for the R/C signal.
Once it has received the MSF signal, the clock automatically displays the correct
time. We recommend that you do not put up or hang the clock during this
process.
If the clock still has not set itself after 12 minutes, reception is faulty or the signal
is not being received at the chosen location. Repeat setting process at a different
location by pressing the RESET button.
Please read carefully before use and retain for future reference.
9765
Snooze/Light
ON/OFF
switch

SETTING/SNOOZING THE ALARM

• To set the time of the alarm, turn the set-alarm knob in the direction of the
arrow in order to set the alarm time. Never turn the set-alarm knob in the
opposite direction to that shown by the arrow as this could damage the works.
• To switch the alarm on, press the ON/OFF switch . At the set alarm time, the
alarm sounds for maximum 2 minutes providing the ON/OFF button is in the
ON position and the snooze button is not pressed.
• To snooze the alarm, press the snooze button on the top of the alarm clock.
The light turns on for 3-5 seconds. The alarm is interrupted for 5 minutes and
then sounds again. The snooze function can be repeated 3-7 times.
Note: If the alarm is not interrupted or switched off, it will stop automatically
after approximately 2 minutes. It is reactivated 12 hours later at the same time.
• To switch off the alarm, push the alarm ON/OFF button down.
To be able to read the clock face when it is dark, briefly press the button on the
top of the alarm clock to illuminate the face. The illumination function is
activated for 5 seconds.
Instructions
Set-alarm
knob
Reset
button
M-set
button
REC
button