Viessmann 6366 Operation Manual page 4

2. Introduction
This lamp uses SMD-LED to produce the light suitable for the lamp
model. Low heat build-up and power input. Nearly unlimited lifetime
of the LED, which means that it is maintenance-free.
3. Mounting
- Remove the lamp carefully from the package.
- Check function before mounting.
- Drill a hole (Ø 1,5 mm) into a wall for mounting the rope
suspension.
- Drill a hole (Ø 2 mm) into the opposite wall to insert the con-
nection cables and to fasten the second rope suspension.
- Insert the connection cables into the holes and fasten the
rope suspensions (fig. 1). Guide the cables through the
recess in the ropes.
- Tension the retaining rope and fasten the two ends with
knots or glue.
4. Connection
Caution:
Resistor and diode at the cables are needed for proper
function of the lamp. Never cut them off!
Never cover resistor or diode with insulation material,
because they have to be cooled by surrounding air!
Connect the LED-lamp to the lighting power output of a model
train transformer (e. g. item 5200) or power supply as shown
in fig. 2 and/or 3.
DC voltage: Connect the diode (red part with black mark)
with the plus pole of the power supply, the resistor with the
minus pole.
AC voltage: Operation with AC voltage could cause some flickering.
We recommend to use the Viessmann power module, item 5215,
which is sufficient for approx. 100 LED-lamps or -reflectors (fig. 3).
Connect the cable to the diode with the brown output socket, the
resistor with the red output socket of the power module.
5. Warranty
Each model is tested to its full functionality prior to delivery.
The warranty period is 2 years starting from the date of
purchase. Should a fault occur during this period please
contact our service department (service@viessmann-modell.
com). Please send the item to the Viessmann service depart-
ment for checking and repair only after consultation. If we find
a material or production fault to be the cause of the failure the
item will be repaired free of charge or replaced. Expressively
excluded from any warranty claims and liability are damages
of the item and consequential damages due to inappropri-
ate handling, disregarding the instructions of this manual,
inappropriate use of the model, unauthorized disassembling,
construction modifications and use of force, overheating and
similar.
6. Technical data
Operating voltage: 10 – 16 V AC ~
Operating current: ca. 10 mA
Subject to change without prior notice. No liability for
mistakes and printing errors.
You will find the latest version of the manual on the Viessmann
website using the item-No.
4
(with and without 5215 power modul)
14 – 24 V DC =
13 – 24 V digital signal
Do not dispose of this product through
(unsorted) domestic waste, supply it to
recycling instead.
Viessmann
Modelltechnik GmbH
Bahnhofstraße 2a
D - 35116 Hatzfeld-Reddighausen
www.viessmann-modell.de
Made in Europe