Tiger MMP-S Manual

Stainless Steel Mug
Instructions
Thank you for purchasing a TIGER Stainless Steel Mug.
Please read the instructions completely before use.
Keep these instructions for future reference.
Safety lock
Unlock
Lid
Press
Button
Body
Protective sheet

Safety Precautions

Safety Precautions
MODEL
MMP-S
Important!
Keep out of reach of children.
Do not put dry ice or
carbonated beverages in the
product.
Do not store milk, dairy
products, or certain fruit juices
in the product.
Do not place the product near
Lid gasket stoves, open flames, or other
sources of extreme heat.
Do not heat the product in a
microwave oven.
Spout
Stopper
Do not fill the product above
Button
the maximum level shown
below.
Stopper gasket
Maximum
level
Be sure to set the stopper in
proper position.
Consume beverage within the
day to prevent from spoiling.
Drink slowly when the product
contains hot beverage.
Noncompliance to this
instruction may result in scald
or injury.
Do not open the lid when it
tilted or near face.
Approx.
1cm ·1/2-inch
Beverage
1
Do not use the product for any
Do not use chlorine-based
purposes other than keeping
bleaches or cleaner when
beverages warm or cold and
cleaning the product.
drinking.
Do not remove the protective
Do not knock over, drop or
sheet on the underside of the
expose the product to
product.
excessive shocks.
Do not attempt to add
Do not disassemble or
beverage when the stopper is
attempt to repair the product
still attached on the product.
by yourself.
Be sure to remove the stopper
Be sure to clean the product before adding the beverage.
immediately, especially for
Be sure to wipe off remaining
sports drinks.
beverage on the spout.
Do not store soups or
beverages containing salt in Keep the product upright
the product. position all the time.
Do not neglect the product in
the bag.
Tips
Tips
To keep your beverage warm or cool longer, pour hot (or cold)
water into the product and let it sit for one or two minutes to
allow the inside of the product to heat (or cool).
The product rattles when shaken.
This is caused by a metal sheet moving inside the product and it doesn't affect the performance
of the product. The metal sheet is used for boosting the performance of heat retention.
2