Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Micropixel PL-1000+
- Page 1 Fingerprint Identification Padlock PL-1000+ Quick Operation Guide V1.1...
- Page 2 Important information: Please read this claims, before using this product Limited warranty: This warranty stated herein shall NOT apply, if: (1) this Product has not been used in accordance with any accompanying instructions, (2) this Product has not been used for its intended functions and environment, (3) the artificial malicious damage or personal negligence cause any defects, (4) if this Product has been opened, modified or repaired anyone other than an authorised service centre, or if it is repaired using unauthorised...
- Page 3 Appearance and function introduction: Charge the battery 1. Open the USB cover 2. Plug in the Micro USB cable and connected to the external power supply, charging red LED lights up 3. Remove the external power supply, while reach the full charge (charging red LED turns off) Unlock 1.
- Page 4 Register fingerprint 1. Unlock the PL-1000+ to get the authorized of registration. 2. When the green Led is still lit, press and hold the shackle continuously until the red and green LED interactive flash and heard a beep sound. 3. Now, release the shackle and start to press your finger onto the fingerprint sensor for scanning your fingerprint, remove your finger when you hear a beep sound and the green LED lights on once.
- Page 5 i-Key (a backup solution for unlock) 1. Open the USB cover 2. Press the shackle of PL-1000+ once, the status green LED is flashing 3. Keep the i-key transmit port facing the sensor window, then press and hold the on/off switch of i-Key directly to unlock PL-1000+.
- Page 6 Appendix A: Trouble shooting Identify fingerprint successfully but it cannot be unlocked Please make sure there is no external tension on the shackle, applying tension to the shackle will affect the motor’s unlocking function. In case, you encountered above situation, please follow out below procedures to unlock 1.
- Page 7 sensor, It will be misjudgment if there’s no enough pressure to apply to the sensor. Make sure the fingerprint(s) what you are using for identification has been registered successfully. Make sure the sensing area of finger is same as your registration.
- Page 8 Appendix B: Caution The following three cases need to charge the battery: 1. The first time use PL-1000+. 2. When the battery capacity has reached the warning status of low battery (the red LED flashes 6 times which occurs after pressing the shackle). 3.
Need help?
Do you have a question about the PL-1000+ and is the answer not in the manual?
Questions and answers