Alarm Display; Parameter Tables - Siemens SENTRON 7KT1681 Manual

Description
3.4 Parameterization
3.4.5

Alarm display

If alarms are activated, the multimeter displays the page with the corresponding status and
the following format:
①
②
③
④
● If the alarm is activated, ON flashes with the triangle symbol.
● If the alarm is deactivated, OFF is displayed continuously.
● If no alarm is programmed, dashes are displayed. After approx. 3 s, the scrolling text for
the alarm programmed in parameter P09.n.05 appears.
● If several alarms are active, the alarm text changes on the display.
● You can use parameter P02.14 for the Utility menu to make the backlighting of the
display flash in the event of an alarm. This makes it more obvious that a fault has
occurred.
● Depending on the settings of parameter P09.n.03, alarms are either reset automatically
when the alarm conditions are no longer fulfilled or they need to be reset by you manually
via the command menu (C.07).
You can find more information on parameters P09 in chapter Parameter setting (setup) from
the front panel (Page 23).
You can find more information on parameters P09 and C.07 in chapter Command menu
(Page 36).
3.4.6

Parameter tables

The tables show all the available programming parameters with the possible setting range,
the factory setting and a description of the parameter function.
28
Alarm deactivated
Alarm text activated
Alarm code activated
Alarm activated
7KT multimeter
Manual, 08/2018, 2514284149-01