All rights reserved. No part of this publication may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying, without prior permission in writing from Tams Elektronik GmbH. Subject to technical modification. Inhaltsverzeichnis 1. What is PhoneControl? 2.
MasterControl which passes on the instructions to the various decoders (locomotive, function, points or switching decoder) on your layout. The PhoneControl does not allow access to data in the locomotive database of the MasterControl or changing of the data.
Connect the EasyNet interface of the PhoneControl via a patch cable (RJ45-cable) to the EasyNet interface of the MasterControl. Any Ethernet patch cable (used in computer networks) will work. You can interrupt or restore the connection of the PhoneControl to the EasyNet at any time – also during operation.
MasterControl and then the button 9 (= stop ) on the hand set. After having pushed the button 9 "STOP" should be shown in the display of the PhoneControl (or of the MasterContol if you have a PhoneControl without display of it´s own).
Selection mode In the selection mode you can select the addresses of locomotive or function decoders you want to enter control instruction for, or make a reset of the PhoneControl. In order to access the selection push: 0 and afterwards *...
Page 7
PhoneControl English Control instructions for locomotive and function decoders Reduce the speed level by one level Change the direction of travel Increase the speed level by one level Reduce the speed level by four levels not used Increase the speed level by four levels...
English PhoneControl 6. Technical Specifications Power supply: via EasyNet Power consumption (without consumer): approx. 150 mA Interfaces: EasyNet Protection: IP 00 Ambient temperature while operating: 0 - + 60 °C Ambient temperature while not operating: -10 bis + 80 °C Maximum humidity: max.