Page 2
Series VABX700 Specifications VIDEO Video Channels: 2-16, scalable Video Format: NTSC, RS-170, RS-250B, PAL, CCIR, and SECAM Video Bandwidth: 6 MHz per channel, 8-bit video SNR: 60 dB min, typical 64dB Intermodulation: Signal Level: 1 V peak-to-peak, 75 ohms Differential Phase: <...
Page 3
ELECTRICAL/MECHANICAL Power Requirements: 0.25A @ 12-16VDC, 5W @ 12-14VAC Connectors: Video BNC, Audio: 6 pin mini din Power: Screw terminals Optical: FC/PC Size: 19” W x12.5”D x 3.18” H Operating Temperature: C to 50 Storage Temperature: C to 85 **NOTE** Dimensions: Units can vary in height, from 1 RU (Rack Unit -1.75”...
VABX700S-T Front Panel INPUT STATUS DATA LASER LEVEL/ LOSS POWER VABX700S-T Rear Panel INPUTS FIBER Video 1 Video 2 Video 3 Video 4 Video 5 Video 6 Video 7 Video 8 Video 9 Video 10 DATA POWER Power Pin # Function Black Shield...
Page 5
VABX700S-R Rear Panel INPUTS FIBER Video 1 Video 2 Video 3 Video 4 Video 5 Video 6 Video 7 Video 8 Video 9 Video 10 DATA POWER Power Pin # Function Black Shield VABX700S-R Front Panel Loss Ready Tx Power Level Link Data...
Page 6
VABX700816S REAR Audio Audio Audio Audio Audio Audio Audio Audio Video 1 Video 2 Video 3 Video 4 Video 6 Video 7 Video 8 Video 9 Audio Audio Audio Audio Audio Audio Audio Audio 9-10 11-12 13-14 15-16 Video 1 Video 2 Video 3 Video 4...
Page 7
ACTION POSSIBLE CAUSE Check for proper primary input No (or low) primary power. power. Blown fuse. Check and replace fuse as re- quired. Check LED on front panel. If not No A/V signal into transmitter. lit, check signal from camera. If lit, replace video board.
Page 8
Insufficient optical power Check optical power at between one or input and output from each more repeaters transmitter and input to and/or Receiver. Receiver. If any transmit- ter outputs are found to Noisy A/V on any or below spec, check bulkhead all channels.
Page 10
OLD STYLE ADAPTER PINOUTS - AUDIO FOR VABX700S Audio Left Audio Right Green (GND) Brown ( - ) Blue ( + ) White ( + ) Black ( - ) Red ( Ground )
Corporation assumes no responsibility for the performance or reli- ability of the product. Radiant Communications Corporation will not be liable for any special or consequential damages, or for loss, damages, or expense directly or in- directly arising from the use of the products or any inability to use them either separately or in combination with any other equipment or material or from any other cause.
Need help?
Do you have a question about the VABX700S Series and is the answer not in the manual?
Questions and answers