Advertisement
Mounting on metal
Mounting on metal
h
= 15 mm
Figure 1
Mounting the MDS D124 / D324 / D424 on RF320T on metal with spacer
Flush-mounting on metal
h
= 15 mm
a
= 35 mm
Figure 2
Flush installation of the MDS D124 / D324 / D424 on RF320T in metal with spacer
Note on mounting/removing transponders
Note the following points when mounting/removing transponders.
● Transponders must be mounted/removed at room temperature.
● The transponder is mounted by pressing it into the holder.
● When removing a transponder, it must be gently levered out by the two holding studs with a tool (for example a flat
screwdriver).
● If the holder is used where the temperature changes often, it is advisable to stabilize the securing screw (for example
with varnish or lock nuts).
2
Spacer for MDS D124 / D324 / D424 and RF320T
A5E03770488-01, 11/2011
Advertisement
