Download Print this page

Polaris SpaWand Pro Instructions

Advertisement

Quick Links

The Polaris SpaWand, SpaWand Pro, and SpaWand ProXL operate by drawing in debris and water as you pull the
handle. When you push the handle in, the water flows out and the dirt, silt and debris are trapped inside the filter.
You must first prime the SpaWand by submerging the nozzle in your spa or pool and pumping the handle in and out
several times. This action removes any air trapped in the SpaWand.
The SpaWand comes with two different nozzles that have three specific uses. The Dual Purpose Nozzle fits directly
onto the SpaWand End-Cap Base and flips to become either a narrow or bell end. The Wide Sweep Nozzle fits over the
narrow end of the Dual Purpose Nozzle.
Dual Purpose Nozzle, Narrow End
A. To remove rocks and large
debris from the spa bottom,
point the narrow end of the
Dual Purpose Nozzle near
the debris and then pull out
the handle.
To clean the filter:
1. Rotate the End-Cap Assembly
until arrows appear in the wide
openings of the End-Cap Base.
2. Gently pull the End-Cap
Assembly and filter screen out
of the End-Cap Base.
End-Cap Base
End-Cap Assembly
End-Cap Base
SpaWand
Dual Purpose Nozzle, Bell End
B. To remove floating debris,
position the bell end of the Dual
Purpose Nozzle over the debris.
Sink it below the surface of the
water and pull out the handle.
Caution: Do not scrape SpaWand nozzles against acrylic spas.
3. Grasp the black band at the
base of the screen. Do not
grasp the filter screen. Gently
rotate the End-Cap Assembly
toward you (about 1/8 turn)
until you feel it stop.
4. Remove the filter screen from
the End-Cap Assembly and
shake out the debris.
5. Line up the notches on the
inside of the black band with
End-Cap Base
the locking tabs on the End-Cap
Assembly; slide the filter screen
End-Cap Assembly
Instructions
®
Wide Sweep Nozzle
C. To remove dirt and silt from the
spa bottom, position the Wide
Sweep Nozzle in front of the
dirt, with the handle pushed in.
Sweep the nozzle forward while
pulling out the handle.
onto the assembly and gently
rotate the assembly away from
you (1/8 turn) until the
filter screen locks into place.
Rinse out any fine silt and flush
any grit from the assembly.
6. Insert the filter, with End-
Cap Assembly, back into the
SpaWand End-Cap Base. Line
up the arrows on the End-Cap
Assembly to appear in the wide
openings of the End-Cap Base.
Rotate the End-Cap Assembly
until your hear a "click" and the
arrows are no longer visible.

Advertisement

loading

Summary of Contents for Polaris SpaWand Pro

  • Page 1 ® The Polaris SpaWand, SpaWand Pro, and SpaWand ProXL operate by drawing in debris and water as you pull the handle. When you push the handle in, the water flows out and the dirt, silt and debris are trapped inside the filter.
  • Page 2 Para usar su SpaWand Polaris El SpaWand de Polaris aspira o succiona el agua y basura al momento de sacar usted la manija del émbolo. Al volver a introducir la manija, el agua sale y la basura queda atrapada dentro del filtro. Antes de usar su SpaWand debe cebarlo, sumergiendo la boquilla en la piscina y bombeando la manija del Èmbolo varias veces.

This manual is also suitable for:

SpawandSpawand proxl