Optionally, the ISD4000 can also measure Heading, Pitch & Roll. Suitable for a large range of underwater applications, the ISD4000 can be used with ROVs, AUVs, Hydro-graphic Survey, Construction, Positioning and any other task where accurate depth and temperature is required underwater.
Innovative Underwater Products 3.0 Overview The ISD4000 is a pressure measurement device – making use of increasing pressure in water to determine depth. It is important to note that the device is designed to provide depth & temperature measurements in water, and will not provide accurate readings when operated in air.
4.1.2 Magnetic Disturbers (For Maximising Heading Performance) Where the heading output is to be used, the ISD4000 should be mounted as far as possible from sources of magnetic interference. Electrical items which can cause magnetic interference include motors, transformers and valve packs.
4.1.4 Heat Sources (For Maximising Temperature Accuracy) In order for the ISD4000 to read the ambient temperature of the water, it should not be installed in close proximity of any heat sources (such as Hydraulic Power Packs).
ISD4000 housing. This can be achieved by using rubber or plastic strips around the body of the ISD4000. The ISD4000 has two flats, on either side of the body – these are to enable the unit to sit tightly against another flat surface if available. These flats also help prevent the unit moving when on the workbench for testing.
Innovative Underwater Products Innovative Underwater Products 4.3 Electrical The ISD4000 is fitted with a SubConn MCBH8M-SS connector as standard. This will mate to a SubConn MCIL8F connector/cable assembly. 4.3.1 Connector Pin Out The standard connector pin out is provided below:...
The Tare function allows the atmospheric pressure reading to be removed prior to deploying the ISD4000. This ensures that all pressure read is purely that of the water depth – enabling a highly accurate depth to be provided.
ISD4000 calibration block. This is available from Impact Subsea. Using the Impact Subsea Software, a calibration of both temperature and pressure can be performed on the ISD4000. The software provides a step by step guide to talk the user through the calibration procedure.
Page 14
Select App Screen Step 3: You will now be presented with the ISD4000 user interface. In order to connect to your ISD4000 unit, please click on the 'Connect' button at the lower left hand side of the screen: ISD4000 User Interface...
Connect Screen Set the Comm Port which you have connected the ISD4000 to. Ensure that the baudrate set matches that printed in the 'Comms' area of the ISD4000 label. Click on the slider which reads 'PORT CLOSED' to open the port.
Heading, Pitch and Roll offsets can also be entered here. 6.2.3 Comms By default the ISD4000 is set to RS232, 9600, N81. The unit can be configured to operate in RS232 or RS485 using all standard baud rates. The required communications setup of the ISD4000 can be configured here.
– this is held in place by the protective cap. Should the diaphragm suffer from physical damage, this will void the warranty of the ISD4000 unit: After cleaning, place the protective cap back on the ISD4000 and secure in place with the locking clip.
Innovative Underwater Products Innovative Underwater Products 8.0 Warranty The ISD4000 is supplied with a Limited Warranty. This warranty applies only to the ISD4000 unit, and only if the ISD4000 is purchased from Impact Subsea Ltd. What does the limited warranty cover? This Limited Warranty covers any defects in material or workmanship under normal use during the Warranty Period.
¦ Fault Description ¦ Remedial action undertaken thus far ¦ If returning your ISD4000 for service or repair, please send the unit, complete with fault report to: FAO: Service Department Impact Subsea Ltd, Unit 10, Castle Street, Castle Road Industrial Estate, Ellon, Aberdeenshire, AB41 9RF, UK.