A1 Security Cameras BN481E82 Quick Installation Manual

BN481E82
Eight-channel Network Recording Kit
UNPACKING
❶
Your system includes the following:
• 8 x Netowrk Dome Cameras
• 8 x Hardware Packs, with:
MounƟng Template,
Expansion Bolts (3),
Self-tapping Screws (3), Hex Wrench,
Startup Guide, and SoŌware CD
Network Video Recorder
• 1 x 8-channel NVR, with:
Pre-installed 2 TB HDD,
AC Power Supply,
Ethernet Cable, Mouse,
Hard Drive SATA Cable, HD Hardware,
Startup Guide, and SoŌware CD
DIMENSIONS
❹
Camera and NVR
375.0 mm
(14.80 in.)
327.50 mm
(12.90 in.)
❷
Cameras
1 Video Output
2 Power Input
❺
53.0 mm
• Ensure the wall or ceiling can support 3x the weight of the
(2.10 in.)
camera.
• If you are connecƟng the IP cameras to the PoE ports of the
NVR, DO NOT connect a 12VDC power supply to the cam-
era. Power will be supplied to the camera via PoE. Proceed
directly to the next step.
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
CONNECTIONS
Camera ConnecƟons
Ethernet, RJ-45
12 VDC or PoE (IEEE 803af)
INSTALLATION
Mount and Make ConnecƟons
CONNECTIONS
❸
NVR ConnecƟons
1 100 to 240 VAC Power IN 6
2 On/Off BuƩon 7
3 PoE, RJ45 (x8) 8
4 Network Switch, RJ45 9
5 USB Port 10
INSTALLATION
❻
Waterproof the Network Connector
• Place the wide side of the rubber ring onto the end of the
network cable extending out from the camera.
• Thread the cable through the Fixing Rubber Ring and the
Waterproof Locking Cover.
• AƩach the male Ethernet connector to the network cable
coming from the camera.
• Connect the other end of the waterproof connector to the
network port and rotate it clockwise to lock the network
port and waterproof connector firmly.
• Slide the Waterproof Locking Cover over the main body of
waterproof connector and rotate it clockwise to seal the
connecƟ on
Audio IN/OUT
VGA OUT
Alarm I/O
HDMI OUT
Ground