Page 1
INSTALLATION INSTRUCTIONS FOR 12 VOLT BORDER LIGHT MODEL 8202 FOR USE ONLY WITH LOW VOLTAGE LANDSCAPE POWER UNITS THAT DO NOT EXCEED 25 AMPS, 15 VOLT MAX. WARNING: Border luminaires must be installed in accordance with the National Electrical Code (NEC) and local codes. Failure to do so will void the warranty and may result in serious injury and/or damage to the Border luminaire.
TOOLS REQUIRED FOR INSTALLATION: Phillips head screwdriver Shovel Wire strippers Silicone grease 1. To prevent electrical shock, disconnect transformer from electrical supply before installation or service. 2. Dig hole approximately 6" diameter by 8" deep as to allow bottom 4" of hole to be filled with pea gravel to facilitate drainage.